Safety · · 6 min read

Lifting Sling Colour Code Explained: Safe Working Load by Colour (EN 1492)

What each lifting sling colour means under EN 1492, how rigging mode changes the safe working load and when a sling must be discarded.

Polyester webbing and round slings showing the lifting sling colour code from violet 1 tonne to orange 10 tonnes

What the lifting sling colour code tells you

Walk onto any UAE site and you will see purple, green, yellow and grey slings hanging in the rigging store. Those colours are not decoration. Under the European textile sling standards, the lifting sling colour code gives a quick visual guide to a sling's working load limit (WLL) in a straight vertical lift. Flat woven webbing slings are covered by EN 1492-1 and round slings by EN 1492-2, and both use the same body-colour sequence.

The colour is a quick check, not the final word. The label sewn to the sling is what counts. This guide explains the colour chart, how the WLL changes with the way you rig the sling, what the label must show and when a sling has to be thrown away.

Lifting sling colour code chart (EN 1492)

Sling colour WLL, straight lift
Violet (purple) 1 tonne
Green 2 tonnes
Yellow 3 tonnes
Grey 4 tonnes
Red 5 tonnes
Brown 6 tonnes
Blue 8 tonnes
Orange 10 tonnes and above

A few points to remember:

  • Orange covers everything from 10 tonnes up. A 10 t and a 20 t round sling can both be orange, so always read the label for heavy slings.
  • Black stripes on webbing are widely used as a second marker, with each stripe usually showing one tonne of straight-lift WLL. This is common industry practice rather than a requirement of EN 1492, so do not rely on stripes alone.
  • Older or non-EN slings may not follow the code. Slings made to other standards, or cheap imports, can come in any colour. Treat an unlabelled sling as unusable whatever its colour.

Label colour shows the material

The body colour shows capacity. The label colour shows what the sling is made of:

  • Blue label: polyester (the most common for general lifting)
  • Green label: polyamide (nylon)
  • Brown label: polypropylene

Material matters because each fibre reacts differently to chemicals. Polyester resists most acids but is attacked by strong alkalis. Polyamide resists alkalis but is weakened by acids. Polypropylene has a lower upper temperature limit than the other two. If a sling may meet chemicals, check with the supplier before use.

What the sling label must show

A compliant EN 1492 sling label normally carries:

  • Working load limit in a straight lift (and often a table for other modes)
  • Material
  • Effective length (EWL)
  • Manufacturer's name or mark
  • Traceability code or serial number
  • Year of manufacture
  • Standard number (EN 1492-1 or EN 1492-2)

If the label is missing, torn off or unreadable, the sling must not be used. Without it, nobody can prove the WLL or trace the sling to its certificate.

Safe working load and the way you rig the sling

The marked WLL applies to a straight vertical lift. How you rig the sling changes how much it can safely carry. The figures below are the mode factors commonly published for EN 1492 textile slings. Always check them against the label or the manufacturer's table for your sling.

Mode of use Mode factor Example: green 2 t sling
Straight lift 1.0 2.0 t
Choke hitch 0.8 1.6 t
Basket hitch, legs parallel 2.0 4.0 t
Basket or 2-leg, 0 to 45 degrees from vertical 1.4 2.8 t
Basket or 2-leg, 45 to 60 degrees from vertical 1.0 2.0 t

Two things catch people out:

  1. Choking reduces capacity. A choke hitch puts a tight bend in the sling and cuts the WLL to about 80 per cent of the marked figure.
  2. Wide angles are dangerous. As the angle between the legs grows, the force in each leg rises sharply. Never rig beyond 60 degrees from vertical, and plan lifts so the angle stays as small as practical.

Textile slings made to EN 1492 are generally designed with a safety factor of 7:1 against breaking. That margin covers wear, shock and small rigging errors. It is not spare capacity to be used.

Worked example: choosing a sling by colour and WLL

Say you need to lift a 2.5 tonne precast unit with two identical slings as a two-leg arrangement, with the legs at about 40 degrees from vertical. The steps are:

  1. Confirm the load weight. Use the delivery note, drawing or a load cell. Never guess.
  2. Pick the rigging mode. Two legs at up to 45 degrees from vertical use the 1.4 mode factor, applied to the WLL of one sling.
  3. Check the rated capacity for that configuration on the label or manufacturer's table, not just the straight-lift colour. Two yellow 3 tonne slings give 3 x 1.4 = 4.2 tonnes; two violet 1 tonne slings give only 1.4 tonnes.
  4. Allow for the centre of gravity. If the load hangs unevenly, one sling takes more than half the weight. Size for the worst-loaded leg.
  5. Add edge protection wherever the sling passes over a corner.

So yellow slings comfortably cover this lift and violet slings do not. The colour narrows the choice quickly. The label and the lift plan confirm it. For anything heavy, awkward or near people, the appointed person or lift supervisor should approve the plan before the load leaves the ground.

Pre-use sling inspection

Before every lift, check the whole sling, including the eyes:

  • Label present and readable, WLL suits the load and rigging mode
  • No cuts, tears or holes in the webbing or round sling cover
  • Round slings: no exposed core yarns through the cover
  • No damaged or broken stitching, especially at the eyes and joins
  • No burns, melted or glazed areas, or hard, stiff patches
  • No chemical contamination or unusual staining
  • No knots tied in the sling
  • Fittings (where used) free of cracks, distortion and wear

When to discard a sling

Take a sling out of use if any of the following applies:

  • The label is missing or unreadable
  • Webbing or cover is cut, torn, abraded or burnt
  • Core yarns are visible on a round sling
  • Stitching is damaged at load-bearing points
  • It has been overloaded or shock-loaded
  • It has been exposed to chemicals not suited to its material
  • It is past its periodic thorough examination date

Mark condemned slings and cut them so they cannot drift back into the rigging store.

Protecting slings on site

Most sling damage comes from sharp edges and heat. Use edge protectors or sleeves on steel beams, precast corners and plant parts. Keep slings out of direct sun when not in use, away from welding and hot surfaces, and off the ground where grit can work into the fibres. Store them hanging on racks in a dry, shaded place.

Thorough examination and records

As well as the pre-use check, textile slings should have a periodic thorough examination by a competent person, with a dated record kept. In Dubai, Dubai Municipality guidelines require lifting equipment and gear to be tested and certified by a third party accredited by the Emirates International Accreditation Centre (EIAC). Check the current intervals and requirements with your main contractor or the relevant authority for your emirate.

When slings are used with cranes, the lift plan should also cover them. Our guide on spider crane vs mobile crane explains how the choice of crane affects the lift, and you can see our mobile crane rental and spider crane rental pages for machines on hire.

Certified lifting slings from APEX PRO

APEX PRO sells and rents certified lifting belts and webbing slings, supplied with the manufacturer's conformity certificate and an inspection certificate. See our lifting belts and slings page for the range, and our certified safety harness page if your crew also needs fall protection.

Tell us the WLL, length and quantity you need through WhatsApp or contact us, and we will confirm stock and delivery to your site.

Frequently asked questions

What colour is a 1 tonne lifting sling?

Under the EN 1492 colour code, a 1 tonne webbing or round sling is violet (purple). The 1 tonne figure is the working load limit in a straight vertical lift. Choke and angled lifts reduce the capacity, so always check the label and the mode factor table before rigging. The label, not the colour, is the binding information.

What does an orange lifting sling mean?

Orange is used for slings with a working load limit of 10 tonnes and above in a straight lift. Because one colour covers every capacity from 10 tonnes upward, you cannot tell a 10 t sling from a 20 t sling by colour alone. Always read the label on orange slings before deciding whether they suit the load.

Does the sling colour code apply to round slings too?

Yes. Flat webbing slings (EN 1492-1) and round slings (EN 1492-2) use the same body-colour sequence, from violet for 1 tonne up to orange for 10 tonnes and above. Slings made to other standards may follow a different scheme or none, so check the standard and WLL on the label every time.

What do the black stripes on a webbing sling mean?

On many webbing slings each black stripe woven into the webbing represents one tonne of straight-lift WLL, so a 3 tonne sling shows three stripes. This is widely used across the industry but is not a requirement of EN 1492, so stripes are only a secondary guide. Confirm the capacity from the label before lifting.

How much does a choke hitch reduce sling capacity?

For EN 1492 textile slings the commonly published choke hitch mode factor is 0.8, meaning the sling can carry about 80 per cent of its marked straight-lift WLL. A green 2 tonne sling in a choke hitch would therefore be limited to about 1.6 tonnes. Check the label or manufacturer's table for your exact sling.

What is the safety factor of a polyester lifting sling?

Textile slings made to EN 1492 are generally designed with a 7:1 safety factor, meaning the minimum breaking strength is about seven times the marked WLL. That margin allows for wear, dynamic loading and small rigging errors. It is not extra capacity, so never load a sling beyond its marked WLL for the rigging mode used.

APEX PRO hire desk
Written by the team that delivers, certifies and services equipment across the UAE every day. About APEX PRO.

More guides

Request a machine

Tell us what the job needs.

Send the form and WhatsApp opens with your request ready to send to +971 50 275 6789. We reply with a written rate showing delivery, fuel and operator separately. Prefer email? Write to hire@apexprouae.com.